Solis · 100A · 10m current sensor clamp
Solis 100A current transformer with 10m lead
This is the Solis 100A current transformer with a 10m lead, the CT clamp specified for the Solis 4G, 5G and S6 inverter ranges. It is a standard van-stock line for any installer fitting or servicing Solis systems.
Delivery in 3–5 working days (estimate). The dispatch clock starts at cleared payment.
Description
The detail that earns it shelf space is coverage: one part listed for the 4G, 5G and S6 ranges, so the same clamp goes out with almost any Solis job you quote. The 10m lead gives you slack where the incoming supply and the inverter are not close neighbours, which describes most retrofits. The 100A rating and single-phase design line up with the domestic work these inverters usually go into. CTs are also the component most often lost, crushed or left on the last job, so a couple of spares in the van is cheap insurance against a return visit.
Specification
| Brand | Solis |
|---|---|
| Part number | SOL-CT-100A-10M |
| Phase | Single-phase |
| Condition | New |
| Category | Parts & accessories · Current Sensor Clamps |
| Delivery method | Parcel courier |
What it pairs with
Fit it alongside single-phase Solis inverters from the ranges it is made for, such as the S6 5kW Dual MPPT single phase or the S6 Plus low-voltage hybrid units in the same catalogue. Where the design calls for separate metering or export control, the Solis Meter 1ph Eastron with external CT and the Solis Export Power Manager 5 Gen sit in the same family. CT and meter requirements vary by model revision, so confirm against the current Solis pairing list.
Listed for the Solis 4G, 5G and S6 ranges, rated to 100A with a 10m lead. Single-phase only. For anything this page can't settle, ask the trade desk before ordering or consult a competent installer.
Often bought alongside
Last updated 2026-07-19